|
Product
Information
1-Large 9x12- Heavy Duty - High Visibility Florescent Plasti-Cloth Sewn Sock Pennant Flag (not a glue
on cheaply that many others sell) Mounted on 1/4 x 36” whip style (flexible) Reinforced Fiberglass Pole safety yellow in color
for added visibility. Florescent Flag Available in Blaze Orange Color,
Heavy –Duty Constructed Mounting Kits . The
mount will accept a deck thickness up to 3/4 of an inch,The mount is made of polyethylene which is a very strong composite
material, with high impact strength,also contains a u/v additive The first kit comes with 2 custom made EPDM Rubber washers
that will not derogate and are not available in stores, also contains stainless steel hareware (no rust factor here)The 2nd
kit comes with a very agressive 1/2 inch well nut w/brass insert and stainless steel hareware, Both Kits Maintenance free
Personal and Non Commercial Use Limitation- These products purchased are for your personal use and some instances
commercial use. You will not at anytime display , copy, reproduce, license, transmit, modify, publish, or make profit from
published information including software product’s and or services taken from North East Visions web site or product lines
Disclaimer- This product is not a toy in any way shape or form. This product is a visual aid only. No guarantee
that this product will alert others of your presence when properly installed and used .Others need to see you in order to
grant right of way and create a safer environment. By purchase of this product the consumer accepts any and all liabilities
with product use. Including any and all modifications of this product done by the consumer, Thank You
|
Please Read Both Sets Of Instuctions Before Installation
The Rispy Comes With 2 Different Mounting Options
Open compartment mounting instructions for the Rispy
1) Drill and 5/16” Drill Bit and safety glasses
2) Permanent Marker
3) The RisPy is designed
to be mounted on the rear / (stern) of watercraft or vehicle. Think about where you would like to position the RisPy so that
it doesn’t interfere with any operations. Twist and unlock the Mount from the flag base and remove all hardware
4)
Place large stainless steel washer on desired flat watercraft or vehicle surface, you may have to off set a bit to find a
flat spot in some cases, Using permanent marker, make a mark through the center of the washer onto the surface to be drilled
, Attention!!! before you drill make sure you can reach your hand underneath the deck or inside the cavity to tighten up the
wing nut
5) Drill hole, Insert carriage bolt into the mount , slide large rubber washer onto the bolt , insert bolt
into drilled hole in deck , Then from underneath take large stainless steel washer followed up by small rubber washer in hand
,slide both onto the bolt , then use wing nut to tighten the mount down to the deck
6) Then place the flag base on
the mount. Then twist and lock into place, and adjust if needed
* Closed compartment mounting instructions for
Rispy *
(Recommended for Ride on Top Kayaks)
1) Place base on a suitable flat surface on the rear
/ (stern) of watercraft or vehicle, Using permanent maker or pencil make a mark using the center of the base as a guide
2) Drill a 1/2 inch hole, Insert well nut into the deck. Then place 3/16 inch washer onto bolt , then insert bolt
into base , thread bolt into well nut , You will need to use a 7/16 socket to tighten down the base and expand the well nut
,
Attention!!!
* We highly recommend you remove the flag assembly(twist and unlock
it ) from the mount anytime you hand carry or transport watercraft and off-road vehicles, Please use safety at all times
. Thank You
The Rispy is Patent Pending,
Rispy is a Regestered Trademark
of North East Visions
www.northeastvisions.net
|
